Epson AcuLaser C2800 - Page 326

AcuLaser C2800/C2800D/C3800/C3800D Revision C
DISASSEMBLY/REASSEMBLY Disassembly/Reassembly 326
Confidential
6. Release the guide pin of the DUCT DRV MAIN, slide the DUCT DRV MAIN to the rear side of the
printer, and remove the DRIVE ASSY MAIN.
7. Disconnect the following connectors: connector of the MAIN MOTOR (P/J211) inside the DRIVE
ASSY MAIN, connector of the SUB MOTOR (P/J221), connector of the DEVE MOTOR (P/J222),
and connector of the EXIT CLUTCH (P/J2761).
8. Remove the clamp, which is attached to the DRIVE ASSY MAIN, together with a harness.
The harness of the connector to be connected to the DEVE MOTOR should pass the far side
of the tab on the DRIVE ASSY PH.
9. Remove the six screws (silver, self-tapping, 10 mm) that secure the DRIVE ASSY MAIN to the main unit.
10. Remove the DRIVE ASSY MAIN from the main unit.
Kmy03059E
A
10)
9)
9)
9)
9)
9)
9)
DRIVE ASSY MAIN