Epson DFX-9000 - Page 150

Epson DFX 9000 Revision B
Disassembly and Assembly AC SW ASY, INLET ASY 143
5. Remove the AC SW ASY by pushing it out from inside the LOWER
UNIT while pressing down the upper locking tab.
6. Pull the AC SW ASY cables out of the LOWER UNIT.
7. Remove the C.P. (S-P1) 4 × 8 screw that secures the INLET ASY
ground wire to the LOWER UNIT.
8. Remove the two C.F. 3 × 4 screws that secure the INLET ASY to the
LOWER UNIT, and remove the INLET ASY.
Figure 4-16. AC SW ASY Removal (2)
Figure 4-17. INLET ASY Removal
C H E C K
P O I N T
To fit the cables through the switch hole, first pull the Blue
and Brown cables from the INLET ASY through, then pull
through the cable and connector for the POWER UNIT.
To
INLET ASY
To
POWER UNIT
AC SW ASY
Push
AC SW ASY
5)-1
5)-2
6)
8)-1
8)-2
8)-1
INLET ASY