Epson DFX-9000 - Page 153

Epson DFX 9000 Revision B
Disassembly and Assembly Safety switches 146
4.2.3.7 Safety switches
INLK SW ASY
1. Remove the UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar. Refer to section 4.2.4.1 PR MECHA ASY, p. 149.
3. Release the INLK SW ASY cable from the three clamps (SIDE
FRAME, RIGHT: 2 places, bottom rear: 1 place).
4. Disconnect the INLK SW ASY cable from the ROM BOARD
(CNINLK: 4 pins), and pull the INLK SW ASY cable out through
the hole in the SIDE FRAME, RIGHT.
5. Remove the C.P. (S-P1) 3 × 16 screw that secures the INLK SW
ASY, and remove the INLK SW ASY.
Figure 4-20. INLK SW ASY Removal
W A R N I N G
 Disconnect the power cable and wait at least 5 minutes
for capacitors to drain before disassembling the
POWER UNIT. If you touch the POWER UNIT with
the power supplied, you may receive an electric shock.
 Do not touch the motors immediately after using the
printer, or you may burn your hand. Allow the motors
to cool enough to work with them.
C A U T I O N
When performing the following procedure, be careful not
to bend the lever of the INLK SW ASY.
3)-1
5)-1
5)-2
3)
INLK SW ASY
ROM BOARD