Epson DFX-9000 - Page 246

Epson DFX 9000 Revision B
Adjustment Software adjustment 239
Adjustment Procedure
1. Open the Top Cover and remove the Ribbon Cartridge and PRINT
HEAD.
2. Install the Dummy-Head part of the APG Gauge Jig, and the APG
PT Jig, in place of the print head on the CARRIER UNIT, as shown
in the figure below.
Figure 5-21. Installing the Jigs
3. Install the Ribbon Cartridge.
4. Close the top cover and turn the printer ON.
5. Set a single sheet of 64 g/m
2
(17 lb) paper on the front tractor, and
press [Load] to feed the paper into the mechanism.
C H E C K
P O I N T
Only the Dummy-Head part of the APG GAUGE JIG is
used for this adjustment.
C A U T I O N
When installing APG PT JIG on the printer, be careful with
its front/back orientation. The correct orientation is
indicated by a label attached to the jig.
APG PT JIG
Dummy-Head