Epson DFX-9000 - Page 247

Epson DFX 9000 Revision B
Adjustment Software adjustment 240
6. From the Adjustment Program, execute the APTC Thickness
Detection Adjustment
.
Figure 5-22. APTC Thickness Detection Adjustment screen
7. Click Enter adjustment mode, and check the displayed paper
thickness value on the printer’s Operation Panel LCD.
8. Press the [Pause] button on the Operation Panel to register the new
paper thickness value for a single sheet of paper.
9. Turn OFF the printer.
10. Turn ON the printer.
11. Press the [LF/FF] button on Operation Panel to eject the paper.
12. Set 10 sheets of stacked or folded 50 g/m
2
(13 lb) paper on the front
tractor, and press the [Load] button on the Operation Panel to load
the paper into the mechanism.
13. Click Enter adjustment mode, and check the displayed paper
thickness value on the printer’s Operation Panel LCD.
14. Press the [Pause] button on the panel to register the new paper
thickness value for 10 sheets of paper.
15. Turn the printer OFF.
16. Turn the printer ON again, and press the [LF/FF] button to eject the
paper.
17. Turn the printer OFF.
18. Remove the jigs from the printer.
C A U T I O N
After registering the adjustment value by pressing the
[Pause] button, be sure to turn OFF the printer.
The value is only stored in EEPROM at power OFF.
APG Count Write
1P = XXXX