Epson DFX-9000 - Page 56

Epson DFX-9000 Revision B
Product Description Operations 49
Notes: 1. When one of the values is not chosen, it shows “Others”.
2. This setting is available only in IBM PPDS emulation mode.
3. When the network card is recognized, these settings display
and can be setup.
4. When the network card is recognized and “Get IP address” is
not “Auto”, these settings display and can be setup.
IBM table
2
Table 2, Table 1
Buzzer Off, On
Low-noise mode Off, On
Auto cut mode Off, On
Auto cut/back Off, On
Overlapping
forms
Off, On
Forms w/labels Off, On
Skip binding Off, On
Get IP address
3
Panel, Auto, PING
IP byte 1
4
000.000.000.000 to 255.255.255.255
IP byte 2
4
000.000.000.000 to 255.255.255.255
IP byte 3
4
000.000.000.000 to 255.255.255.255
IP byte 4
4
000.000.000.000 to 255.255.255.255
SM byte 1
3
000.000.000.000 to 255.255.255.255
SM byte 2
3
000.000.000.000 to 255.255.255.255
SM byte 3
3
000.000.000.000 to 255.255.255.255
SM byte 4
3
000.000.000.000 to 255.255.255.255
GW byte 1
3
000.000.000.000 to 255.255.255.255
GW byte 2
3
000.000.000.000 to 255.255.255.255
GW byte 3
3
000.000.000.000 to 255.255.255.255
GW byte 4
3
000.000.000.000 to 255.255.255.255
Table 1-35. Setting values available in Selectype (continued)
Setting Items Setting Values