EasyManua.ls Logo

Epson DFX-9000 - Page 58

Epson DFX-9000
333 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Epson DFX-9000 Revision B
Product Description Operations 51
1.3.4.2 Special service functions
Clear EEPROM
This function resets the printer to the standard factory settings. Note that
these settings may not be correct for all geographical markets.
To initialize the EEPROM, turn the power on while holding down the
[Pause], [Micro Feed ], and [LF/FF Lord] buttons.
NOTE: After clearing the contents, the factory default parameters
are set.
Panel lock out mode
You can restrict the use of buttons on the control panel using the Panel
Lock Out mode. In the default setting, you can only use the Pause, Load,
and Tear Off buttons when Panel Lock Out mode is on. These settings
can be changed using the Power-on default setting mode, p. 51.
To turn on the Panel Lock Out mode, perform the following:
1. Make sure the printer is turned off.
2. Turn on the printer while holding down both the [Font] and [Pitch]
buttons. The printer beeps twice, indicating that the panel lock out
mode has been turned on.
To turn off the panel lock out mode, repeat steps 1 and 2. The printer
beeps once, indicating that the panel lock out mode has been turned off.
The table below shows the available custom lockout settings, with the
factory default settings underlined.
Notes: 1. If Unlock is selected, the switch function is enabled whether
Panel Lock Out mode is on or off.
2. If Lock is selected, the switch function is disabled when Panel
Lock mode is on.
Power-on default setting mode
You can change some parameters that the printer refers to when it is
initialized. To change the Power-On Default settings:
1. Make sure paper is loaded and turn the printer off.
2. Turn on the printer while holding down the [Font] button to enter
default-setting mode. The message Setting mode appears on the
LCD panel.
C A U T I O N
This function should only be used for emergency recovery
of the factory default settings.
Table 1-36. Panel lock out mode - setting status
Item Setting Values
Pause Unlock, Lock
Micro Feed Unlock, Lock
Load Unlock, Lock
LF Unlock, Lock
FF Unlock, Lock
Top of Form Unlock, Lock
Tear Off Unlock, Lock
Font Unlock, Lock
Pitch Unlock, Lock
Front/Rear Unlock, Lock
Menu Unlock, Lock
Reset Unlock, Lock

Table of Contents

Other manuals for Epson DFX-9000

Related product manuals