Epson DFX-9000 - Page 59

Epson DFX-9000 Revision B
Product Description Operations 52
3. Select one of the three main menus by pressing the [Set↑] (Tear Off)
or [Set↓] (Top of Form) button: Print settings, Form w/labels, or
Panel lock out.
4. If you select Print Settings, press the [Item↓] (Pitch) button to print
the current settings.
If you select Form w/labels or Panal lock out, press the [Item↑]
(Font) or [Item↓] (Pitch) button to select the items you want to
change.
5. Press the [Set↑] (Tear Off) or [Set↓] (Top of Form) button to select
the values within the selected parameter until you find the desired
setting.
6. After setting the selected parameter to the desired value, you may
either continue to make changes to other parameters by pressing the
[Item↓] button or the [Item↑] button, or exit the power-on default-
setting mode.
7. When you finish the settings, turn the printer off.
The values available for power-on default and factory settings are shown
in the table below. The underlined value is the factory default settings.
Notes: 1. Refer to Panel lock out mode, p. 51 for details.
2. This setting is the function that prints the current settings.
Error analysis mode (acquire EEPROM information)
This printer mode allows the host system to communicate with the
printer while it is in an error state.
To enable Error Analysis mode, turn the power on while holding down
the [Front] and [Pitch] buttons. The printer beeps once, and enters IEEE
1284.4 Protocol mode.
NOTE: The printer forcibly enters IEEE 1284.4 packet mode even if
a fatal error has occurred, and communication with the PC
becomes available. This mode is used with the Adjustment
Program to get information from the printer when it is in a
fatal error condition.
C H E C K
P O I N T
The instructions and current settings are printed out in the
language that you set in the SelecType mode. If you want
to change the language, change the language setting in the
SelecType mode. See 1.3.3 SelecType functions setting
(p.46) for details.
C H E C K
P O I N T
In Step 3 to 5 above, you can scroll through the values by
holding down the [Set↑] (Tear Off), [Set↓] (Top of Form),
[Item↑] (Font), or [Item↓] (Pitch) button for a few seconds.
C H E C K
P O I N T
The menu is designed as a loop. After the last menu
parameter is displayed, the next menu item will be the first
menu.
Table 1-37. Values available in default setting mode
Item Setting Values
Select settings Forms w/labels, Panel lock out
1
, Print settings
2
Label base pos. Paper left edge, First dot
Label top pos. 0/216 inches to 4752/216 inches
Label length 0/216 inches to 4752/216 inches
Label left pos. 0/120 inches to 1440/120 inches
Label width 0/120 inches to 1440/120 inches
Base sheet PG 0 to 14
Label paper PG 0 to 14