Epson DS-790WN

Encrypted Communication Using IPsec/IP Filtering
About IPsec/IP Filtering
You can lter trac based on IP addresses, services, and port by using IPsec/IP Filtering function. By combining of
the ltering, you can congure the scanner to accept or block specied clients and specied data. Additionally, you
can improve security level by using an IPsec.
Note:
Computers that run Windows Vista or later or Windows Server 2008 or later support IPsec.
Conguring Default Policy
To lter trac, congure the default policy. e default policy applies to every user or group connecting to the
scanner. For more
ne-grained
control over users and groups of users,
congure
group policies.
1.
Access Web Cong and then select the Network Security tab > IPsec/IP Filtering > Basic.
2.
Enter a value for each item.
3.
Click Next.
A conrmation message is displayed.
4.
Click OK.
e scanner is updated.
Related Information
& “Running Web Cong on a Web Browser” on page 34
Default Policy Setting Items
Default Policy
Items Settings and Explanation
IPsec/IP Filtering You can enable or disable an IPsec/IP Filtering feature.
❏ Access Control
Congure a control method for trac of IP packets.
Items Settings and Explanation
Permit Access Select this to permit congured IP packets to pass through.
Refuse Access Select this to refuse congured IP packets to pass through.
IPsec Select this to permit congured IPsec packets to pass through.
Advanced Security Settings > Encrypted Communication Using IPsec/IP Filtering > Conguring Default Policy
101