Epson DS-790WN

2.
Select Start.
e connection test is started. Aer the test, the check report is displayed.
LDAP Server Connection Test References
Messages Explanation
Connection test was successful. This message appears when the connection with the server is successful.
Connection test failed.
Check the settings.
This message appears for the following reasons:
❏ The LDAP server address or the port number is incorrect.
❏ A timeout has occurred.
❏ Do Not Use is selected as the Use LDAP Server.
❏ If Kerberos Authentication is selected as the Authentication Method,
settings such as Realm (Domain), KDC Address and Port Number (Kerberos)
are incorrect.
Connection test failed.
Check the date and time on your
product or server.
This message appears when the connection fails because the time settings for the
scanner and the LDAP server are mismatched.
Authentication failed.
Check the settings.
This message appears for the following reasons:
❏ User Name and/or Password is incorrect.
❏ If Kerberos Authentication is selected as the Authentication Method, the
time/date may not be congured.
Cannot access the product until
processing is complete.
This message appears when the scanner is busy.
Setting the Email Server
When you use Scan to My Email, set Email Server.
Note:
You can s et Scan to My Email only when Scan to Email has been enabled.
When setting up from Web Cong:
Select the Network tab > Email Server > Basic.
When setting up from Epson Device Admin:
Select Common > Email Server > Mail Server Settings from the conguration template.
Item Settings and Explanation
Authentication Method Specify the authentication method for the scanner to access the mail server.
O Authentication is disabled when communicating with a mail
server.
SMTP AUTH The email server needs to support SMTP authentication.
POP before SMTP When you select this item, set a POP3 server.
Authentication Settings > Registering and Setting Information > Setting the Email Server
141