Registering and Setting Information
Setting Up
Make the necessary settings depending on the Authentication Method and the scanning method you use.
c
Important:
Before starting the setup, check that the time setting for the scanner is correct.
If the time setting is incorrect, the error message "License is expired" is displayed, which may lead to failure to set up
the scanner. Also, in order to use a security function such as SSL/ TLS communication or IPsec, the correct time
must be set. You can set the time as follows.
❏ Web Cong: Device Management tab > Date and Time > Date and Time.
❏ Scanner’s control panel: Settings > Basic Settings > Date/Time Settings.
Settings Local DB LDAP Local DB and
LDAP
Enabling authentication
You need to enable authentication before making
authentication settings.
“Enabling Authentication” on page 130
✓✓✓
Authentication Settings
Setting the Authentication Method and how to authenticate
the user.
“Authentication Settings” on page 130
✓✓✓
Registering User Settings
Register the settings for each user. You can also register
users in bulk by using a CSV le.
“Registering User Settings” on page 131
✓ – ✓
Synchronizing with the LDAP Server
Make the LDAP server synchronization settings.
“Synchronizing with the LDAP Server” on page 138
– ✓✓
Setting the Email Server
Set the email server settings. Set this when using functions
that requires email server settings such as Scan to My Email.
“Setting the Email Server” on page 141
✓✓✓
Setting Scan to My Folder
Set the destination folders. Set this when using the Scan to
My Folder function.
“Setting Scan to My Folder” on page 142
✓✓✓
Authentication Settings
>
Registering and Setting Information
>
Setting Up
129
To Next Page
Loading...
