Epson DS-790WN

Web Cong
Web Cong is an application that runs in web browsers such as Internet Explorer and Safari on a computer. You
can conrm the scanner status or change the network service and scanner settings. Since the scanners are accessed
and operated directly from the network, it is suitable for setting up one scanner at a time. To use Web Cong,
connect your computer to the same network as the scanner.
e
following browsers are supported.
Microso
Edge, Windows Internet Explorer 8 or later, Firefox
*
, Chrome
*
, Safari
*
*Use the latest version.
Running Web
Cong
on a Web Browser
1.
Check the scanner's IP address.
Select Settings > Network Settings > Network Status on the scanner's control panel. en select the active
connection method status (Wired LAN/Wi-Fi Status or Wi-Fi Direct Status) to conrm the scanner's IP
address.
2.
Launch a Web browser from a computer or smart device, and then enter the scanner's IP address.
Format:
IPv4: http://the scanner's IP address/
IPv6: http://[the scanner's IP address]/
Examples:
IPv4: http://192.168.100.201/
IPv6: http://[2001:db8::1000:1]/
Note:
Since the scanner uses a self-signed certicate when accessing HTTPS, a warning is displayed on the browser when you
start Web Cong; this does not indicate a problem and can be safely ignored.
3.
Login as an administrator to change the scanner settings.
Click Log in at the top-right of the screen. Enter the User Name and Current password, and then click OK.
Note:
❏ e following provides the initial values for the Web Cong administrator information.
·User name: none (blank)
·Password: serial number of the scanner
To nd the serial number, check the label attached to the rear of the scanner.
❏ If Log out is displayed at the top-right of the screen, you have already logged-on as an administrator.
Running Web Cong on Windows
When connecting a computer to the scanner using WSD, follow the steps below to run Web Cong.
Software for Setting Up the Scanner > Web Cong > Running Web Cong on Windows
34