Connecting a Smart Device and Scanner Directly (Wi-Fi Direct)
Wi-Fi Direct (Simple AP) allows you to connect a smart device directly to the scanner without a wireless router
and scan from the smart device.
About Wi-Fi Direct
Use this connection method when you are not using Wi-Fi at home or at the oce, or when you want to connect
the scanner and the computer or smart device directly. In this mode, the scanner acts as an wireless router and you
can connect up to 8 devices to the scanner without having to use a standard wireless router. However, devices
directly connected to the scanner cannot communicate with each other through the scanner.
e scanner can be connected by Wi-Fi or Ethernet, and Wi-Fi Direct (Simple AP) connection simultaneously.
However, if you start a network connection in Wi-Fi Direct (Simple AP) connection when the scanner is
connected by Wi-Fi, the Wi-Fi is temporarily disconnected.
Connecting to a Smart Device using Wi-Fi Direct
is method allows you to connect the scanner directly to smart devices without a wireless router.
1.
Select
on the home screen.
2.
Select Wi-Fi Direct.
3.
Select Start Setup.
4.
Start Epson Smart Panel on your smart device.
5.
Follow the instructions displayed on the Epson Smart Panel to connect to your scanner.
When your smart device is connected to the scanner, go to the next step.
6.
On the scanner's control panel, select Complete.
Network Settings
>
Adding or Replacing the Computer or Devices
>
Connecting a Smart Device and Scanner Dir
…
21
To Next Page
Loading...
