Epson DS-790WN

Receiving access from a specied IP address only
is example allows a specied IP address to access the scanner.
Default Policy:
❏ IPsec/IP Filtering: Enable
❏ Access Control:Refuse Access
Group Policy:
❏ Enable this Group Policy: Check the box.
❏ Access Control: Permit Access
❏ Remote Address(Host): IP address of an administrator’s client
Note:
Regardless of policy conguration, the client will be able to access and congure the scanner.
Conguring a Certicate for IPsec/IP Filtering
Congure
the Client
Certicate
for IPsec/IP Filtering. When you set it, you can use the
certicate
as an
authentication method for IPsec/IP Filtering. If you want to congure the certication authority, go to CA
Certicate.
1.
Access Web
Cong
and then select the Network Security tab > IPsec/IP Filtering > Client
Certicate
.
2.
Import the certicate in Client Certicate.
If you have already imported a certicate published by a Certication Authority, you can copy the certicate
and use it in IPsec/IP Filtering. To copy, select the certicate from Copy From, and then click Copy.
Related Information
& “Running Web Cong on a Web Browser” on page 34
& “
Conguring
a CA-signed
Certicate
” on page 94
& “
Conguring
a CA
Certicate
” on page 98
Connecting the Scanner to an IEEE802.1X Network
Conguring an IEEE802.1X Network
When you set IEEE802.1X to the scanner, you can use it on the network connected to a RADIUS server, a LAN
switch with authentication function, or an access point.
1.
Access Web
Cong
and then select the Network Security tab > IEEE802.1X > Basic.
2.
Enter a value for each item.
If you want to use the scanner on a Wi-Fi network, click Wi-Fi Setup and select or enter an SSID.
Note:
You can share settings between Ethernet and Wi-Fi.
Advanced Security Settings > Connecting the Scanner to an IEEE802.1X Network > Conguring an IEEE802. …
111