Epson DS-790WN - Page 81

2.
Enter the necessary information in Current password, User Name, New Password, and
Conrm
New
Password.
Enter at least one character for the new password.
Note:
e following provides the default values for the administrator information.
❏ User name: none (blank)
❏ Password: serial number of the scanner
To nd the serial number, check the label attached to the rear of the scanner.
c
Important:
Be sure to remember the administrator password you set. If you forget your password, you will not be able to
reset it and you will need to request help from service personnel.
3.
Select OK.
Related Information
& “Running Web Cong on a Web Browser” on page 34
Changing the Administrator Password from the Control Panel
You can change the administrator password from the scanner's control panel.
1.
Select Settings on the scanner's control panel.
2.
Select System Administration > Admin Settings.
3.
Select Admin Password > Change.
4.
Enter your current password.
Note:
e setting at the time of purchase (default value) for the administrator password is the serial number of the scanner.
To nd the serial number, check the label attached to the rear of the scanner.
5.
Enter your new password.
Enter at least one character.
c
Important:
Be sure to remember the administrator password you set. If you forget your password, you will not be able to
reset it and you will need to request help from service personnel.
6.
Enter the new password again for conrmation.
A completion message is displayed.
Basic Security Settings > Administrator Settings > Conguring the Administrator Password
81