Epson Expression 10000XL - Page 56

Expression 10000XL Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 56
5. Slide the TPU CR Motor Unit in a direction of the arrow, then make the TPU CR
Motor Belt bow and remove it.
Figure 4-46. Removal of TPU CR Motor Belt
6. Lift the TPU CR Motor Unit, and remove the one screw (CP, M3x4) that is securing
the Earth Cable, then remove the TPU CR Motor Unit.
7. Remove the four screws (M3x10) that are securing the TPU CR Motor, and remove the
TPU CR Motor.
Figure 4-47. Removal of TPU CR Motor
TPU CR Motor Belt
Step 5-1
Step 5-2
M3x10
(50±10Ncm)
Earth Cable
TPU CR Motor
M3x10
(50±10Ncm)
When reinstalling the CR Motor screws, install them in the following
order.
1. Put the CR Motor Belt on the Pinion Gear.
2. Tighten the screw tentatively.
3. Install the Extension Spring.
4. Tighten the screws.
42
2
1
3
4