1. Make sure the paper guide is removed, and set the paper
thickness lever to the single-sheet position. Also make sure the
paper thickness lever (located under the printer cover) is set to 0.
2. Slide the left paper guide of the cut-sheet feeder so it is
aligned with the triangle mark. Next, slide the right paper
guide to roughly match the width of your paper. Slide the
paper support midway between the paper guides.
-1
1
2
3
4
5
6
G4-6
paper support
paper guides of the
cut-sheet feeder
G4-8-2
L
Gentian Rev.c
A5 size Chapter 4
97/06/20 pass 0
4-8
Printing on Single Sheets
To Next Page
Loading...
