5. Remove the front cover by pushing it straight down as shown
below.
6. Make sure your paper has a clean, straight edge. Then open
both sprocket covers and fit the first four holes of the paper,
printable side up, over the tractor pins.
7. Close the sprocket covers.
8. Slide the right sprocket to remove any slack in the paper; then
lock it in place by pushing the sprocket lock down.
g3-9-1
G3-10-2a
3
R
Gentian Rev.c
A5 size Chapter 3
97/07/04 pass 2
Printing on Continuous Paper
3-9
To Next Page
Loading...
