Why is my Epson LX-300+ not turning on?
If your Epson printer is not receiving power, start by checking the power cord to ensure it is securely plugged into the electrical outlet. If it is, verify that the outlet is functioning correctly by plugging in another electrical device, such as a lamp. If the outlet is controlled by a switch or timer, try a different outlet.
What to do if an unknown error has occurred on my Epson LX-300+ Printer?
If an unknown error has occurred on your Epson printer, turn off the printer and leave it off for a few minutes. Then, turn it back on. If the error continues, contact your dealer.
What to do if an unknown printer error has occurred on my Epson LX-300+?
If an unknown error has occurred with your Epson printer, turn it off and leave it off for several minutes, then turn it on again. If the error continues, contact your dealer.
How to resume printing on my Epson LX-300+ Printer when it's paused?
If the Epson printer is paused, press the Pause button to resume printing.
Why is paper feed abnormal on Epson printer?
If your Epson printer's paper feed is abnormal, replace the sensor if the RPE detector or BPE detector is defective or not connected properly. If the paper switching mechanism or printer mechanism paper loading mechanism is defective, replace the printer mechanism or paper loading mechanism parts. If the PF motor is defective, replace it. If the PF motor driver is defective, replace the main board.
What to do if a single sheet of paper is not fully ejected from my Epson Printer?
If your Epson printer isn't ejecting a single sheet of paper fully, press the Load/Eject button to eject the sheet completely. Then, if necessary, press the Pause button to turn off the Pause light.
What to do if Epson LX-300+ Printer shows fatal error?
If your Epson printer experiences a fatal error possibly due to a carriage error, ensure there are no obstructions hindering the carriage's movement. If the fatal error stems from an abnormal input voltage, verify the power supply voltage. Should the issue be a hardware problem, inspect the machine and electric circuit.
Why does control panel LED not operate on Epson LX-300+?
If your Epson printer's control panel LED isn't working, it could be due to several reasons. First, check the electric circuit and printer mechanism for a short circuit; if none exists, replace the fuse. Other potential solutions involve replacing the power board if the connector isn't connected, the power switch is defective, or the power board itself is defective. Ensure CN8 is properly connected if the power board and main board aren't connected correctly. If the main board is defective, it should be replaced. Also, check that the control panel harness is properly connected, and if the control panel board or harness is defective, replace the control panel.
What to do if Epson LX-300+ becomes fatal error when power is applied?
If your Epson printer experiences a fatal error upon powering on, ensure the CR motor harness and HP detector harness are properly connected. If the CR motor or HP detector are defective, replace them. Also, consider replacing the power board. In some cases, replacing the main board and printer mechanism might be required.
Why is printing operation abnormal on Epson printer when it is on-line?
If your Epson printer's printing operation is abnormal when it is online, reset the settings or use the EEPROM clear to reset the settings to the default. Ensure the interface cable is properly connected and replace it if defective. If the issue persists, the main board or firmware might be defective and require replacement.
General| Emulation | Epson ESC/P, IBM PPDS |
|---|---|
| Print Method | 9-pin, impact dot matrix |
| Interface | Parallel |
| Paper Handling | Friction feed |
| Dimensions | 366 x 275 x 159 mm |
| Paper Width | 4 - 10 inches |
To Next Page
