Epson LX-300+ Service Manual

LX-300+/1170 Revision C
PRODUCT DESCRIPTION
S
PECIFICATIONS 19
o
Envelop
Figure 1-3. Printable Area for Envelop
o
Continuous paper
Figure 1-4. Printable Area for Continuous Paper
Table 1-7. Printable Area for Envelop
Envelope Printable Area
PW (Width) Refer to 1.7 "Paper Specifications"
PL (Length) Refer to 1.7 "Paper Specifications"
LM (Left Margin) 3 mm or more
RM (Right Margin) 3mmormore
TM (Top Margin) 4.2 mm or more
BM (Bottom
Margin)
4.2 mm or more
NOTE: The maximum horizontal printable area is 203.2mm.
P r i n t a b l e A r e a
L M
T M
R M
B M
Table 1-8. Printable Area for Continuous Paper
Continuous Paper
PW (Width) Refer to 1.7 "Paper Specifications"
PL (Length) Refer to 1.7 "Paper Specifications"
LM (Left Margin) LX-300+:
13 mm or more (PW<=254 mm)
24mm or more(PW=254 mm)
LX-1170:
13 mm or more (PW<=377.8mm)
18 mm or more(PW=406.4 mm)
P r i n t a b l e A r e a
P e r f o r a t i o n
P e r f o r a t i o n

Epson LX-300+ Specifications

General

Emulation	Epson ESC/P, IBM PPDS
Print Method	9-pin, impact dot matrix
Interface	Parallel
Paper Handling	Friction feed
Dimensions	366 x 275 x 159 mm
Paper Width	4 - 10 inches