Epson RC90 User Manual

Maintenance 6. Alarm
There are three states of the alarm.
Display
Status
OK
An alarm is configured. An alarm is not occurring.
Expired
An alarm is occurring. Replacement is required.
Not set
An alarm is not configured.
6.3 How to Edit the Alarm Information
The configured alarm information can be edited in the EPSON RC+ 7.0.
(1) Select EPSON RC+ 7.0 menu-[Tools]-[Maintenance] to display the [Controller
Tools] dialog box.
(2) Select the alarm to be changed and click the <Change> button.
(3) Display the [Change Alarm] dialog box and enter any of the followings.
Purchase or replacement date of the battery
Date of grease up
(4) Click the <OK> button and change the specified alarm information.
6.4 Alarm Notifying Method
The alarm notifying method needs to be configured by the output bit of the Remote I/O.
The Remote I/O can be configured in the EPSON RC+ 7.0- [Setup] - [System
Configuration] - [Controller] - [Remote Control].
For details, refer to the EPSON RC+ 7.0 User’s Guide 12.1 Remote I/O.
The controller does not enter the error or warning state even if an alarm occurs.

NOTE

NOTE
RC90 (EPSON RC+ 7.0) Rev.4 99

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English