Epson RC90 User Manual

Maintenance 7. Maintenance Parts Replacement Procedures
7. Maintenance Parts Replacement Procedures
WARNING
■
B
efore performing any maintenance procedure, a
lways make sure that the
main power
of the Controller is turned OFF and that the high voltage charged
area is completely discharged.
Performing any maintenance procedure while
the main power is ON or the high voltage charged area is not
discharged
completely is extremely hazardous and may result in electric shock and/or
cause serious safety problems.
■
When opening or closing the front side, make sure that the 200 V power supply
for the Controller is OFF. Performing procedure to the power supply terminal
block inside the Controller while the power supply is ON is
extremely
hazardous and may result in electric shock and/or cause serious safety
problems.
- Be careful not to damage cables.
- Be sure not to drop any screws into the Controller.
7.1 Fan Filter
Inspect the fan filter periodically and clean it when needed. The temperature inside the
Controller may get too high and the Controller may not operate properly if the filter is not
kept clean.
For the inspection schedule of the fan filter, refer to Maintenance 2. Regular Maintenance
Inspection.
Fan Filter
Remov
al
(1)
Turn OFF the Controller.
(2)
Remove two screws of the fan filter.
(3)
Remove
the fan filter cover.
(4)
Detach
the fan filter.
Vacuum off the dust when cleaning the filter.
Fan Filter
Installation
(1)
Set the fan filter to the fan filter cover.
(2)
Mount
the fan filter cover with two screws.
(3)
Plug in
the power connector. Turn ON the Controller and make sure that
the
Controller starts properly without any vibration or abnormal noise.

NOTE
RC90 (EPSON RC+ 7.0) Rev.4 101

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English