Epson RC90 User Manual

Setup & Operation 7. LAN (Ethernet Communication) Port
7.3 Changing Controller IP Address
In this section, the procedure to change the Controller IP address when connecting
Controller development PC connection port and the development PC by the USB cable is
indicated.
(1) For connection between the development PC and the Controller, refer to Setup &
Operation
5. Development PC Connection Port.
(2) Select the EPSON RC+ 7.0 menu-[Setup]-[Controller] to display the following dialog.
(3) Select [Controller]-[Configuration].
(4) Enter the proper IP address and subnet mask and click the <Apply> button.
(5) Click the <Close> button. The Controller reboots automatically.
IP address configuration is completed and the Controller reboot dialog disappears.
When the Controller and the development PC are connected via the Ethernet, the
Controller IP address can also be changed. However, Controller and the development PC
do not connect automatically after rebooting the Controller at Ethernet connection.

NOTE
RC90 (EPSON RC+ 7.0) Rev.4 39

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English