Epson RC90 - Typical Output Circuit Application 2: Source Type

Setup & Operation 11. I/O Connector
Typical Output Circuit Application 2: Source Type
CAUTION
■
Be
sure to wire the output circuit properly because it has no protection circuitry
for
short-circuit and reverse-connection.
Improper wiring may cause
malfunction of the parts on the board and then
improper function of the robot
system.
17 Output No.0 to 7 Common
11 Output No.1
10 Output
No.0
12
Output No.2
13 Output No.3
L
L
GND
+DC
33 Output No.8 to 15 Common
L
Omit
～
～
～
～
29 Output No.8
14 Output No.4
15 Output No.5
27
Output No.6
30 Output No.9
(Same)
(Same)
(Same)
(Same)
(Same)
(Same)
(Same)
28 Output No.7
56 RC90 (EPSON RC+ 7.0) Rev.4