Maintenance 9. Troubleshooting
No. Message Remedy Note 1 Note 2
Calibration number is out of range.
Calibration is not defined.
Camera orientation is out of range.
TwoRefPoints flag is out of range.
6005
Cannot calculate the point position because there
Cannot calculate because
there is invalid data.
Coordinate transformation failed. Cannot
calculate because there is invalid data.
Calibration file name is invalid.
Calibration file is not found.
Failed to read the calibration file.
Failed to write the calibration file.
9 pixel coordinate points should be specified.
18 pixel coordinate points should be specified.
9 robot coordinate points should be specified.
18 robot coordinate points should be specified.
9 robot coordinate points and 1 reference point
should be specified.
6019
9 robot coordinate points and 2 reference points
Vision process Critical error (-1)
6501
Vision process Hardware does not supported
Vision process Communication error (-3)
Vision process Memory error (-11)
Vision process Invalid image size (-12)
Vision process Invalid image version (-13)
Vision process Error at modeling (-14)
Vision process Recovery error(-15)
Vision process Invalid repetition count (-16)
Vision process Invalid mode (-17)
Vision process Invalid threshold value (-18)
Vision process Invalid polarity (-19)
Vision process File open failed (-20)
Vision process Initialization error (-21)
Vision process Status error (-22)
Vision process Invalid flag(-23)
Vision process Invalid model (-24)
Vision process Invalid image format (-25)
Vision process Invalid range type (-26)
Vision process Invalid kernel size (-27)
Vision process Invalid property value (-100)
Vision process Exposure termination process
failed (-201)
Vision process Invalid pixel to pixel operation
(-10001)
Vision process Invalid Blob property structure
size (-11001)
Vision process Invalid Blob result header
structure size (-11002)
6532
Vision process Invalid Blob result item
structure size (-11003)
RC90 (EPSON RC+ 7.0) Rev.4
173
To Next Page
Loading...
