Epson RC90 User Manual

Maintenance 9. Troubleshooting
No. Message Remedy Note 1 Note 2
10000 Command aborted by user
10001 Command timeout.
10002 Bad point file line syntax
10003 Project could not be built.
10004 Cannot initialize Spel class instance.
10005
Cannot initialize parser.
10006
Cannot initialize wbproxy.
10007 Project does not exist.
Check whther the project name and
the path are correct.
10008
No project specified.
Specify the project.
10009 Cannot open file.
Check whether the project name
and the path are correct.
10010
Cannot create file.
10011 File not found
Check whether the project name
and the path are correct.
10013
Cannot execute LoadPoints with Robot
Manager open.
Close the robot manager and
execute.
10014
Project cannot be locked. It is being used
by another session.
Terminate other applications.
10015
Project could not be synchronized.
10016 Drive not ready
Check whether the drive
designation is correct.
10017
Invalid IP address
Check the IP address.
10018
Invalid IP mask
Check the IP mask.
10019
Invalid IP gateway
Check the IP gateway.
10020
IP address or gateway cannot be the subnet
address.
Check the IP address.
10021
IP address or gateway cannot be the
broadcast address.
Check the IP address.
10022
Invalid DNS address
Check the DNS.
10023
Commands cannot be executed because
the project build is not complete.
Execute after the project build is
completed.
10024
Invalid task name.
Check the task name.
10100
Command already in cycle.
10101
Command aborted by user.
10102 Invalid server instance. Specify the correct instance.
10103
Invalid CommandTask value.
Specify the correct task number.
10104
Cannot change ServerInstance after
initialized.
Set ServerInstance before
initialization.
10501 Connection aborted.
10502 Cannot connect with the controller.
10503
Controller firmware is not compatible with
this version of RC+.
Upgrade the RC+ version.
10504
USB connection of this system is reserved
for the RC620 Controller and cannot be
used for RC+7.0.
Install the RC+7.0 to another
computer.
10505 The specified connection does not exist. Check the connection number.
10600 Frame grabber driver not installed. Install the driver.
RC90 (EPSON RC+ 7.0) Rev.4
196

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English