Epson Stylus Photo RX700 - Page 162

EPSON Stylus Photo RX700 Revision A
Maintenance Lubrication 162
 Lubrication of CR Motor Unit
 Lubrication of Driven Pulley Assy
Figure 6-24. Lubrication of the CR Motor Unit
Figure 6-25. Lubrication of the Driven Pulley Assy
Table 6-20. Lubrication of CR Motor Unit (Scanner Unit)
Assy to be Lubricated
(Reference Page)
Lubrication Points/Amount of Application Type
Precautions
(Fig No.)
Motor Holder (p.99)
 Lubrication Points: Shafts (x2)
 Amount of Application: 0.01~0.03g
(Apply with a brush)
G-26
Figure 6-24
 Lubrication Points: Rotating surface on washer
 Amount of Application: 0.01~0.03g
(Apply with a brush)
G-26
Drive Seat (p.99)
 Lubrication Points: Sliding surface (x2)
 Amount of Application: 0.01~0.03g
(Apply with a brush)
G-26
Tension Pulley (p.99)
 Lubrication Points: Shaft
 Amount of Application: 0.01~0.03g
(Apply with a brush)
G-26
CR Motor Unit (p.99)
 Lubrication Points: Motor Gear ~Idle Pulley
engaged area
 Amount of Application: 0.01~0.03g
(Apply with a brush)
G-26
Table 6-21. Lubrication of Driven Pulley Assy (Scanner Unit)
Assy to be Lubricated
(Reference Page)
Lubrication Points/Amount of Application Type
Precautions
(Fig No.)
Driven Pulley Holder
(p.99)
 Lubrication Points: Shaft
 Amount of Application: 0.01~0.03g
(Apply with a brush)
G-26 Figure 6-25
Bottom face side