Epson Stylus Pro 9000 - Disassembling the I;C Holder

EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 105
4.2.4.2 Disassembling the I/C Holder
1. Unhook the hooks fixing the upper I/C guide and slide it backward. Then,
slide out a metal bracket that holds the I/C ID sensor board.
2. Remove the two screws (CP(W2) M3x4) securing the “HOLDER ASSY.,
VALVE, A” to a base frame.
3. If necessary, remove the I/C In sensor assembly or the Ink Low sensor
assembly .
Figure 4-58. I/C Holder
Figure 4-59. I/C Holder Disassembly (1)
Figure 4-60. I/C Holder Disassembly (2)
I/C ID Sensor board
Upper I/C guide
Base frame
“HOLDER ASSY., VALVE,A”
Metal bracket
Bottom I/C guide
Upper I/C guide
Metal bracket
Bottom I/C guide
I/C In sensor
Ink low sensor