Epson Stylus Pro 9000 - Important Maintenance Items During Service Operations; Lubrication

EPSON Stylus Pro 9000 Revision B
Maintenance & Setup General Maintenance Issues 148
6.1.3 Important Maintenance Items During Service
Operations
Check the following items during printer maintenance/service and perform any
necessary operations.
6.1.4 Lubrication
In this product, there are no required lubrication parts.
Table 6-3. Items to be Checked During Maintenance/Service
Items Check Points Remedy
Lower Paper Guide
and the surface of the
Subplaten
Make sure no paper,
dust, or foreign objects
are attached or have
accumulated.
Cleaning (If there is an
ink stain, wipe with dry,
clean cloth after
cleaning the ink stain
with damp cloth.)
Step Ruler
(Striped plastic sheet
used by Linear
Encoder to determine
CR position)
Make sure no dust or
foreign objects are
attached or have
accumulated, and
make sure it is not
ripped, bent, or
stained.
After attempting to
clean, if there are any
rips or stains, replace
with new one.
Rail on the CR guide
frame
Make sure thereare no
foreign objects
attached.
Cleaning
P_REAR sensor and
P_FRONT sensor
surface
Make sure no paper,
dust, or foreign objects
are attached or have
accumulated.
Cleaning
CAUTION
Therefore, never lubricate the printer mechanism
since the lubrication may damage the mechanical
parts and shorten the product life.