Epson Stylus Pro 9000 - Control Panel Settings; Selectype Menu

EPSON Stylus Pro 9000 Revision B
Product Description Control Panel 22
1.3.2 Control Panel Settings
To access the control panel settings, press the SelecType button while the
printer is not printing. The printer enters the SelecType mode and cannot print.
The following table lists LCD display messages in SelecType mode.
Selecting a menu provides you with detailed options.
SELECTYPE MENU
Notes:
* The printed image is the same size as a printed image using the 3mm setting; however, the
printer adds 12mm of paper clearance (for a total margin of 15mm) to the top and bottom edges
to make paper feeding more stable and to prevent the paper from rubbing the printheads.
Also, the underlined item equals the default.
Table 1-15. Control Panel Settings
Display Message Menu
SelecType Menu SelecType menu, page 22
Test Print Menu Test Print Menu, page 23
Printer Status Menu Printer Status Menu, page 23
Paper Settings Menu User Paper Settings, page 23
Cutter Replacement Menu Cutter Replacement Menu, page 24
Head Alignment Menu Gap Adjustment Menu, page 24
Table 1-16. SelecType Menu
Display Message Item Notes
PLATEN GAP
Auto
Thick
Adjusts the platen gap. (Normally, leave
set to Auto.)
PAGE LINE
ON
OFF
When Auto Cut Off is selected on the
control panel, this setting determines
whether a line for manual cutting is
printed.
INTERFACE
Auto
Parallel
MAC
Option
Determines which interface the printer
checks for data. Auto continuously checks
all interfaces and is good for normal use.
PARALLEL
INTERFACE
Compatible
ECP
Determines the data transfer rate when
using this interface.(Normally, leave set to
Compatibility.)
CODE PAGE
PC437
PC850
Character code setting. (PC437:
expanded graphics/PC850: multi-lingual)
ROLL PAPER
MARGIN
Top/Bottom 15mm
15mm
3mm
Roll sheet margin setting.
• Top/Bottom 15mm*: the top and bottom
margins = 15mm while left and right
margins = 3mm
• 15mm: all margins = 15mm
• 3mm all margins = 3mm
INITIALIZEPANEL Run Initialize control panel setup values