Epson Stylus Pro 9000 - Windows: Increasing Print Speed

EPSON Stylus Pro 9000 Revision B
Troubleshooting Troubleshooting Using the Error Messages 65
RELOAD PAPER

Problem
This error occurs when,
1) The front edge is loaded too far and the paper is not in the loading
position after it is reverse fed.
2) The paper was loaded in such a way that the left and/or right edge is
out of the printable area (due to mis-loading or because the paper is too
wide).
3) After printing has finished, the right or left edge is out of the area where
the cutter can cut the paper.
4) The loaded paper was longer than the selected paper, and the paper
was not fully ejected. (For example, roll paper is loaded in the printer but
cut sheet is selected on the control panel.)
5) A cutter error occurred after the paper was ejected.
 Solution
 1~3 above
Properly reload paper. If the front edge of the paper is not straight and
clean, cut the paper.
 4~5 above
Cut of the section of the paper that has ejected/protruded and reload
the rest of the paper. For paper that is automatically cut, lift up the
Release Lever (the “Load Paper” message appears), fix the position of
the paper, and lower the Release Lever. If you select you “Roll Paper/
Auto Cut” setting, you can cut off the protruding part of the paper using
the Cut button.
 If the error recurs even after reloading the paper, make sure the paper-
end sensor on top of the carriage is installed correctly and working
properly.
PUSH LEVER DOWN

Problem
The printer is not able to continue paper feeding/initializing, printing, or ink
sequencing because the Release lever was moved to the Release
position. Or, the printer cannot begin printing because the lever is in the
release position.
 Solution
 Push down the lever. However, if printing was interrupted because the
lever was pushed to the release position and the paper shifted, the
print job may be marred.
 If the lever is down and this error still occurs, check the Release-Lever
position sensor.
COMPARTMENT OPEN

Problem
An Ink Holder (I/H) compartment door is open.
 Solution
 Push the I/H lever down to the lock position.
 If the lever is down and this error still occurs, check the lever position
sensor.