Epson Stylus Pro 9000 - Cut Sheet Media Handling

EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 93
REMOVING THE INTERLOCK SWITCH (L/R)
1. Remove the L/R side cover (refer to "L/R Side Covers Removal" on page
75).
2. To remove the interlock switch (R), disconnect the cable from the
connector CN13 on the relay board.
3. Remove the two screws (CP(W2) M3x6) securing the interlock switch
mount plate to the side frame, and remove the interlock switch (R) together
with the mount plate.
Figure 4-33. Interlock Switch (R) removal
4. To remove the interlock switch (L), disconnect the cable from the
connector CN27 on the C277MAIN board.
5. Remove the two screws (CP(W2) M3x6) securing the interlock switch
mount plate to the side frame, and remove the interlock switch (L) together
with the mount plate.
Figure 4-34. Interlock Switch (L) removal
CN13