Epson Stylus Pro 9000 - Summary; Adjustment Tools; Caution

EPSON Stylus Pro 9000 Revision B
Adjustment Summary 107
5.1 Summary
This section describes the adjustment procedures necessary after replacing
certain parts and explains how to perform those adjustment procedures.
5.1.1 Caution
Before beginning any adjustment procedure, make sure of the following.
5.1.2 Adjustment Tools
The necessary tools for performing adjustment procedures on this printer are
shown below.
CAUTION
n Before starting any adjustment procedure, find the
adjustment procedure you need to perform in
Table 5-2 on page 108 and verify the order or the
tasks you need to perform.
n When performing an adjustment procedure, double-
check the detailed instructions and caution
information for that procedure; otherwise you may
damage the printer.
n To make proper adjustment, make sure to avoid
strong light (sun-light) around the printer. Since this
printer uses photo-sensitive devices (photo-
sensors), the printer may not function properly if it is
operated under such conditions.
n When replacing the following, always install a new
ink cartridge.
• Printheads
• Main Board
• "Holder, Assembly, Valve"
Table 5-1. Adjustment Tools
Name Part Code Notes
Tension Gauge B747700300/
standard tool
acceptable
Max. 4000g
Tension Gauge
#F712
1047744/
standard tool
acceptable
Max. 200g
Straight edge/ruler
1000mm #F713
1047746/
standard tool
acceptable
Length: 1000mm
Scale Stopper 1047745/
standard tool
acceptable
Used in combination with #F713
(0.1mm scale)
CR Cover-Position
Adjustment Tool
#F724
Special Tool
1049975
Material: Plastic
Color: White
Flash Memory Card
#F727
1050073
standard
PC card
acceptable
Type: 2MB Flash memory card
Standard: Type-II (PCMCIA Rel 2.1/
JEIDA Ver. 4.2)
Voltage: 5V Read/Write
Self-Training Kit
#F708
1047105 CD-ROM based