Epson Stylus Pro 9000 - Removing the Hd_Slid Motor Assembly

EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 90
5. Remove the two CP(W2) M3x8 screws securing the PF Motor Assembly to
the PF Motor Frame, and then remove the PF Motor Pulley. If necessary,
hold the PF Motor Frame to reduce the tension and make the motor
assembly removal easy.
Figure 4-27. PF Motor Assembly Removal
REMOVING THE HD_SLID MOTOR ASSEMBLY
1. Remove the R side cover (refer to "L/R Side Covers Removal" on page
75).
2. Disconnect the cable from the connector CN18 on the relay board.
3. Remove the two screws (CP(W2) M3x8) securing the HD_SLID motor
assemblytothesideframe.
Figure 4-28. HD_SLID Motor Assembly Removal
ADJUSTMENT
REQUIRED
When removing/installing the Lower Paper Guide, the
following adjustment procedure is required.
- Cutter Position Adjustment
CP(W2) M3x8
CP(W2) M4x12 screws: only
ADJUSTMENT
REQUIRED
When removing/installing the HD_SLID Motor assembly, the
following adjustment procedure is required.
- Gear backrush adjustment