EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 77
ROLL COVER ASSEMBLY REMOVAL
1. Remove the Maintenance Cover as described in “Maintenance Cover
Removal” on page 73.
2. Remove the H Top Cover as described in “H Top Cover Removal” on
page 74.
3. Remove the L/R Side Covers as described in “L/R Side Covers Removal”
on page 75.
4. Remove the four screws (CP(W2) M3x8), two on each side, that secure the
Roll Cover Shaft.
5. From the outer sides of the L/R Side Frames, remove the Cover Gear
Assemblies, and then remove the Roll Cover Assembly.
Figure 4-10. Roll Cover Assembly Removal
CP(W2) M3x8
CP(W2) M4x8
Left side of Roll
Right side
To Next Page
Loading...
