Epson Stylus Pro 9000 - Cutter Replacement Menu; Gap Adjustment Menu; Maintenance Errors

EPSON Stylus Pro 9000 Revision B
Product Description Control Panel 24
CUTTER REPLACEMENT MENU
The following table includes the steps/messages that must be followed to
replace the cutter.
GAP ADJUSTMENT MENU
Note: The underlined item equals the default.
1.3.3 Maintenance Errors
There are several consumable parts in the printer, and the printer employs
separate counters to keep track of each one. The “Maintenance Req. 0100”
message appears on the display to warn that the Waste Ink pads are about
99% full and need to be replaced soon.
The printer can continue to print even though the “Maintenance Req. 0100*
message appears instead of the “Ready” or “Printing” message. However,
when the waste ink counter determines the Waste Ink pads are 100% full, the
“Service Req 00000100” message appears and the printer can no longer print.
To clear the Maintenance error, perform the following.
Replace: The following seven items are need to be replaced.
- Waste Ink Pads (R/L)
- Pump Assembly
- Cap Assembly
-FBox(R/L)
- Cleaner, Head
Required Adjustments: The following adjustments are need to be performed
after replacing the corresponding items.
- Waste Ink Counter Clear
(See “Maintenance Mode 2” on page -26.)
- Cleaner Counter
(See “Maintenance Mode 2” on page -26.)
- Cutter Position Adjustment
(See “Cutter Position Adjustment” on page 140.)
Table 1-20. Cutter Replacement Messages
Display Message Item Notes
CUTTER REPLACEMENT Execute Prepare a replacement cutter and
OPEN LOWER COVER - Open the front cover.
REPLACE CUTTER -
Remove the old cutter and install a
new one.
CLOSE LOWER COVER -
Close the front cover. The printer is
ready.
Table 1-21. Platen Gap Adjustment Menu
Display Messages Item Notes
ADJUSTMENT
PATTERN
Print All
Print #1~12
Selects which patterns to print. (All patterns
or selected patterns only.)
SELECT #1-12 1~4~7 Choose a pattern from #1 to #12.
PAPER
THICKNESS
Standard
0.0~1.6mm
Select the thickness, to 0.1mm, of the
paper you are using to check the platen
gap. Normally, leave set to Standard.
CHECK
PO INT
The above mentioned seven items are available as a kit.
Description: MAINTENANCE KIT
Parts code: 1048434