EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 74
H TOP COVER REMOVAL
1. Remove the Maintenance Cover. See “Maintenance Cover Removal” on
page 73.
2. Remove the four screws, CP(W2) M4x12, that secure the left-side lower
mounting bracket and remove the bracket. Repeat for the right-side lower
mounting bracket.
Figure 4-4. Lower Mounting Bracket Removal
3. Remove the four screws, two silver CP(W2) M3x6 and two silver CP(W2)
M4x6.
4. Lift the H Top cover from the rear edge, and carefully tilt it forward, and lift
it away from the printer.
Figure 4-5. H Top Cover Removal
Mounting brackets
(lower)
CAUTION
When lifting the H Top Cover off the printer, be careful not
to catch the rear edge of the Cover on the P-Thick sensor
lever which is in the paper path to the right of center. If the
P-Thick sensor is knocked out of position, the printer
cannot properly determine the paper thickness.
CP(W2) M3x6 screws
CP(W2) M4x6 screws
To Next Page
Loading...
