Epson Stylus Pro 9000 - Front Cover Assembly Removal

EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 76
FRONT COVER ASSEMBLY REMOVAL
1. Remove the Maintenance Cover as described in “Maintenance Cover
Removal” on page 73.
2. Remove the H Top Cover as described in “H Top Cover Removal” on
page 74.
3. Remove the L/R Side Covers as described in the previous section.
4. Remove the three screws (CP(W2) M3x8) securing the damper assembly
on the left side, and then remove the damper assembly.
5. As shown below, the Front Cover Assembly is supported by a shaft and
brackets on both sides. The shaft is secured to these brackets with three
screws (CP (W2) M3x8), two on the right and one on the left.
Figure 4-8. Locations of Front Cover shaft screws
Figure 4-9. Front Cover Removal
CP(W2) M3x8
Left side
Right side
CHECK
PO INT
The roll assembly parts and guide on the left side of the
Front Cover shaft are not fixed and will slide off the shaft if
the shaft is tilted down to the left.