Epson Stylus Pro 9000 - Unpacking and Assembling; From Unpacking to Assembling the Stand

EPSON Stylus Pro 9000 Revision B
Maintenance & Setup Unpacking and Installing 151
6.2.3 Unpacking and Assembling
FROM UNPACKING TO ASSEMBLING THE STAND
1. Remove the band connecting the large box and medium size box, and take
out the medium size box.
2. Open the medium size box and verify the contents. (See the previous
page.)
3. Install the top and bottom horizontal stand supports (holes facing correct
direction) to the right-side leg and temporarily secure the top support with
the hexagonal bolts (M6 x 10). Repeat for the left-side leg
4. Turn over the stand so that the bottom faces up. Then, connect the bottom
support and secure the support with the hexagonal bolts (M6 x 30).
5. Turn over the assembled stand again, and completely secure the top-
support bolts.
CAUTION
n It is recommended at least two people (four for
printer body) unpack and assemble the stand.
(Weight of stand: approximately 22kg after
assembling.)
n Perform unpacking and assembly in a stable, open
place (about 4 x 4m).
CHECK
PO INT
Make sure the four holes on the upper support are on
the left when facing the rear and on the right when
facing the front.