EPSON Stylus Pro 9000 Revision B
Adjustment Adjustment Steps 125
FLUSH POINT RIGHT AND LEFT ADJUSTMENT
This function corrects the flushing position of the carriage to make sure the
carriage is properly positioned over the F Box R/L during the flushing
operation.
1. Put a piece of paper over the flushing box.
2. Make sure "Adj. Flush Point x" ("x" = R or L) appears in the LCD, and press
the Enter button.
3. The carriage moves to the flushing position and begins flushing.
4. After flushing is finished, "Point x NNN" ("x" = R or L, NNN = numeric
position) appears. Check the piece of paper you put over the flushing box
to confirm the ink is ejected into the flushing box. If the ink-flushing position
is correct, press the Enter button to finish. Otherwise, press the SelecType
or Item button to correct the flushing position. The settings increment as
follows.
Correction distance: One press = 1/720 inch
Direction: "+" = toward HP and "-" = away from HP
x Flushing
Perform flushing operation
Flushing Point x: -123
Use the item select Paper Feed [+] or [-]
button to adjust the flushing position
("+" = to HP, "-" = away from HP)
[Enter]
End
adjustment/
next menu
To Next Page
Loading...
