Epson Stylus Pro 9000 - L;R Side Covers Removal

EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 75
L/R SIDE COVERS REMOVAL
1. Remove the Maintenance Cover as described in “Maintenance Cover
Removal” on page 73.
2. Remove the H Top Cover as described in “H Top Cover Removal” on
page 74.
3. Remove the left and right joint-cover plates (between the stand and
printer).
4. Remove the seven screws (five silver CP(W2) M4x12 screws and two
black CP(W2) M4x12) securing the Left Side Cover, and remove the Left
Side Cover. Repeat for the Right Side Cover plus remove one cable from
the back of the control panel.
Figure 4-6. L/R Side Cover Screw Location - Inner
Figure 4-7. L/R Side Cover Screw Location - Outer
CP (W2) M4x12 silver screws
CP (W2) M4x12 silver screws
CP (W2) M4x12 black screws