EPSON Stylus Pro 9000 Revision B
Troubleshooting Troubleshooting Using the Error Messages 61
SERVICE REQ. 00010006
Problem
CR motor overcurrent - Feedback from the CR motor (IC33) driver’s 10-pin
output (Sense signal) indicates that the PF motor’s current is irregular.
Solution
Replace the CR motor
Replace the Main Board
SERVICE REQ. 00010007
Problem
CR in-position time-out - The in-position time is the amount of time the
printer waits to make sure the carriage is not moving when the carriage
comes to a stop. The linear encoder is activate for the predetermined “in-
position time” and if the encoder sends a pulse, this means the carriage is
moving even though it is supposed to be at a full stop, this generates an
error.
Solution
Replace the encoder sensor
Replace the CR motor
Replace the Main Board
SERVICE REQ. 00010008
Problem
Servo interrupt watchdog time-out error due to motor-drive control related
error
Solution
Replace the Main Board
SERVICE REQ. 00010009
Problem
System interrupt watchdog time-out error due to sensor-related error
Solution
Replace the Main Board
SERVICE REQ. 0001000A
Problem
CR origin sensor malfunction - CR home position sensor malfunction
Solution
Replace the HP sensor
Replace the Main Board
SERVICE REQ. 0001000C
Problem
PG origin sensor malfunction (may indicate PG motor malfunction)
Solution
Make sure there is no ink or dust on the surface of the sensor. If this does
not solve the problem, check the PG sensor connection. If there still is a
problem, try the following.
Replace the PG sensor
Replace the PG motor
Replace the Main Board
SERVICE REQ. 0001000D
SERVICE REQ. 0001000E
Problem
Cover sensor malfunction - one or both cover open sensors (interlock
switch) located at either end of the cover shaft is malfunctioning.
(00): right sensor (HP side)
(01): left sensor
Solution
Make sure the sensor(s) are properly installed. If that does not solve the
problem, check the cover open sensor connection. If there still is a
problem, try the following.
Replace the malfunctioning cover sensor
Replace the Main Board
To Next Page
Loading...
