Epson Stylus Pro 9000 - Maintenance Assembly Removal & Disassembly

EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 91
MAINTENANCE ASSEMBLY REMOVAL & DISASSEMBLY
1. Remove the right-side Waste Ink Box as described in “Replacing the
Waste Ink Pads” on page 83.
2. Remove the two (CP(W2) M4x6) screws securing the Maintenance
Assembly frame to the printer.
Figure 4-29. Maintenance Assembly Removal - 1
3. From the R Side Frame, remove the one (CP(W2) M3x6) screw securing
the Maintenance Assembly upper frame.
4. Disconnect the two cables from the connectors CN9 (to CR Lock Solenoid)
and CN19 (to Pump motor), and then remove the Maintenance Assembly.
Figure 4-30. Maintenance Assembly Removal - 2
CHECK
PO INT
If the “Service Call 00000100” error occurs, you need to
replace the Waste Ink Pads and F Box R as well as replace
the Pump Assembly, Cap Assembly, and Head Cleaner on
top of the Maintenance Assembly. In addition, you need to
reset the following counters. (See “Service Related Printer
Settings” on page 26.)
n INIT. WASTE INK
n INIT. CLEANER
YoualsoneedtoperformtheCutterPositionAdjustment.
Two screws: towards
the back of the
One
screw:
from
outer
CAUTION
When removing the Maintenance Assembly, the ink tubes
connected to the Pump Assembly may leak or drip ink. It is
a good idea to wipe the ends of these ink tubes off before
removing the Maintenance Assembly.
One screw