EPSON Stylus Pro 9000 Revision B
Troubleshooting Troubleshooting Using the Error Messages 66
INK OUT
Problem
One or more ink cartridges have run out of ink, a near-end cartridge has
been reinstalled, or an unsupported ink cartridge has been installed.
Solution
Replace the empty ink cartridge.
Make sure the ink cartridge is the proper type of cartridge for the
printer and the proper color for that slot.
If the proper cartridge is installed and this error still occurs, check the
Ink-End sensor and the Ink ID sensor.
NO INK CARTRIDGE
Problem
An ink cartridge is not installed or is not installed properly.
Solution
Install the proper ink cartridge in the empty slot.
If the proper cartridge is installed and this error still occurs, check the
Ink-Cartridge sensor.
REMOVE PAPER
Problem
Printer cannot perform cleaning because of thick paper. (The printheads
are too far away from the Cap Assembly.) This error occurs under the
following conditions.
Thick paper is loaded when the periodic/timer cleaning operation is
supposed to begin.
The printer attempts to print on thick paper when the periodic/timer
cleaning operation is supposed to begin.
You turn on the printer and the thick paper is loaded.
You attempt to perform a manual cleaning operation when thick paper
is loaded.
Solution
Remove thick paper and push the Release lever down. (This causes the
cleaning to operation to start and “Wait” appears on the display.) After the
cleaning operation is finished, “Paper Out” appears. Load thick paper.
OPTION I/F ERROR
Problem
An unsupported Type-B interface card is installed.
Solution
Turn off the printer, remove the unsupported card, and install a supported
card.
CAUTION
When replacing an empty ink cartridge, always replace
it with a new ink cartridge; otherwise the printer
cannot determine how much ink remains.
CAUTION
When replacing an empty ink cartridge, always replace
it with a new ink cartridge; otherwise the printer
cannot determine how much ink remains.
To Next Page
Loading...
