Epson Stylus Pro 9000 - Buttons; LED Indicators

EPSON Stylus Pro 9000 Revision B
Product Description Control Panel 20
BUTTONS
All of the buttons on the control panel, and their functions, are described below.
Notes:
1: Interrupts ink drying and runs the specified operation.
2: 1.27cm/second paper feed for 2 seconds after key is pressed.
7.62cm/second paper feed if pressed for over two seconds.
Maximum feed of 20cm with one press of the button.
3: 1.27cm/second paper feed for 2 seconds after key is pressed.
7.62cm/second paper feed if pressed for over two seconds.
LED INDICATORS
Note: *Also occurs if no cartridge is installed or the wrong cartridge is installed.
Table 1-12. Control Panel Buttons & Functions
Button
(Second function)
Function
(Normal)
SelecType
Function
Power-On
Function
Power Power on/off N/A N/A
Pause
(Reset)
• Switch - online/off-line
• Reset (press for three
seconds
N/A
Maintenance
mode
SelecType
Enters SelecType mode
(when printer is in Standby
mode)
Selects menu or major
category
N/A
Cut/Eject
(Enter)
Selects *1
• Auto Cut
• Cutter Off
• Sheet
Confirm and save value
Paper Feed ↑ Feeds paper backward *2
Cycles backward/
increases value
Paper Feed ↓
(-)
Feeds paper forward *3
Cycles forward/
decrease value
Paper Source
(Item)
Selects paper source
Selectsitemorminor
category
Cleaning
Cleans both heads if
pressed for three seconds
N/A
Paper Source
Cut/Eject
Paper Feed ↓
N/A
Maintenance
Mode 2
Paper Source
Cut/Eject
Cleaning
N/A
Firmware
Update Mode
Table 1-13. LED Indicators
LED Status Condition
Operate
•On
•Flashing
• Power on
• Receiving data or performing power-down
sequence
Paper Out
•On
•Flashing
• No paper loaded
• Paper jam
Pause
•On
•Flashing
• Printer ready
• Performing head cleaning or the printer is in ink
drying phase. Also flashes during ink charging
operation.
Ink Out Y
•On
•Flashing
•Inkout*
•Inklow
Ink Out LM
•On
•Flashing
•Inkout*
•Inklow
Ink Out LC
•On
•Flashing
•Inkout*
•Inklow
Ink Out M
•On
•Flashing
•Inkout*
•Inklow
Ink Out C
•On
•Flashing
•Inkout*
•Inklow
Ink Out K
•On
•Flashing
•Inkout*
•Inklow
Paper Source
(Auto Cut)
On Roll paper will automatically be cut.
Paper Type
(Cut Off)
On
Roll paper will not be cut. (When using the optional
Take-up Roller, you need to select this setting.)
Paper Type
(Single Sheet)
On Single sheet printing mode.