Epson Stylus Pro 9000 - Adj Check Nozzle

EPSON Stylus Pro 9000 Revision B
Adjustment Adjustment Steps 119
ADJ CHECK NOZZLE
After the initial ink charge, this function verifies that the nozzles are properly
firing ink If the some nozzles are not firing correctly or at all, you can run the
cleaning operation from this menu.
1. Make sure "Adj: Check Nozzle" appears on the LCD and press the Enter
button.
2. Load paper if not already loaded and replace any low or empty ink
cartridges if detected. If these conditions are OK, the printer prints the
following check pattern.
The pattern includes the following colors from left to right; black, cyan,
magenta, yellow, light magenta, and light cyan.
3. When the check pattern is finished printing, "Nozzle Check End" appears
ontheLCD.Ifthepatternprintedallsixcolorsproperlywithnolinesordots
missing, press the Enter button to end this adjustment procedure. If lines or
dots are missing, press the SelecType button to start the cleaning cycle.
Please Set Paper
Load paper.
Please Set Ink
Replace any low or empty ink cartridges.
Printing Pattern
[SelecType]
[Enter]
End
adjustment/
proceed to
next
Nozzle Check End
Cleaning Standard
Print Adj. Pattern