EPSON Stylus Pro 9000 Revision B
Product Description Control Panel 21
1.3.1 Control Panel Messages
Printer status and error messages appear on the control panel display. The
table below lists the messages by order of importance.
Notes:
*1: If the printer’s platen gap setting is set to Thick, a “W” will appear in the last space on the
LCD display.
*2: See “Service Errors” on page 25.
*3: See “Maintenance Errors” on page 24.
Table 1-14. LCD Messages
Display Message Meaning
Service Call nnnnnnnn *2
Fatal error
Maintenance Call nnnn *3
Printer requires maintenance from qualified service
person (such as replace waste ink tank)
Wait *1
Resetting Timer IC
Clearing NVRAM
Performing reset operation
Performing ink sequence operation
Initializing the printer
Dealing with initial paper operation
Switching Power Off
Preparing to shut down.
Install Ink Cartridge
Replacing ink cartridge.
Cover Open
The cover is open.
Option I/F Card Error
A Type-B interface error has occurred.
Lower Release Lever
Paper Release lever is in the release position.
Load xxx Paper
Wrong paper loaded.
Paper Jam
Paper is caught inside the printer.
Paper Not Cut
Printer did not cut the paper (when Auto Cut selected)
Paper Skew
Paper was fed at an angle, and the printer stopped to
prevent printing the page offcentered.
Paper Out
End of roll or sheet (or the paper detect sensor may
have dust or grime blocking its operation)
Reload Paper
Paper check error
Compartment Open
Replacing ink cartridge
Replace Cartridge
An ink cartridge is empty
Press Pause Button
Waiting for paper initialize start trigger
Pause
Pause state.
Ink Drying xx *1
Printer waits xx minutes before the next print job to
allow ink on previous print job time to dry.
Ink Low
Prepare a replacement cartridge for the color ink
indicated.
Printing *1
Processing print data.
Ready *1
Can receive and print data.
Reset
In the process of re-initializing.
Restart Printer
Turn the printer off and turn it on again.
Table 1-14. LCD Messages (continued)
Display Message Meaning
To Next Page
Loading...
