EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 96
REMOVING THE CR-HP SENSOR AND ENCODER
1. Remove the H-TOP cover (refer to "H Top Cover Removal" on page 74).
2. Remove the two screws (CP(W2) M3x6) securing the cable connection
plate to the carriage assembly at both left and right sides.
3. Disconnect the cables from the connectors on the CR-RELAY board:
CN2 = to Linear Encoder
CN4 = to CR-HP Sensor
Figure 4-39. Disconnect the cables
Figure 4-40. Removing the screws (L/R)
Screw
Screw
To Next Page
Loading...
