EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 97
4. Dismount the connection plate from the carriage assembly as shown
below.
5. Remove the two screws (CP(W2) M3x6) each securing the CR-HP sensor
and the encoder sensor assemblies to the back of of the cable connection
plate, and remove them.
Figure 4-41. Removing the CR-HP sensor / Encoder sensor
CAUTION
Do not damage the timing fense (slit film) when removing /
attaching the encoder.
CR-HP Sensor
Encoder Sensor
To Next Page
Loading...
