Epson Stylus Pro 9000 - Sensors

EPSON Stylus Pro 9000 Revision B
Adjustment Adjustment Steps 133
SENSORS
This function allows you to confirm the sensors are operating properly. The
current status (ON or OFF) of the sensors (one at a time) is shown in the LCD
display, and you need to check the sensor operation by hand. For example, to
check the Release Lever position sensor, move the lever up and down.
o PaperEdgeAD
Displays the status of the P_EDGE sensor.
o PaperFrontAD
Displays the status of the P_FRONT sensor.
o PaperRearAD
Displays the status of the P_REAR sensor.
o Ink lever B
Displays the status of the black-side (K/C/M) ink holder lever.
o Ink lever C
Displays the status of the color-side (Lc/Lm/Y) ink holder lever.
o Ink ID
The Ink ID sensor is a 3-bit sensor, and the ID number appears as 0~7.
Sensor on = 1 and sensor off = 0.
o XInkNOTyy
Describes which cartridge is not installed if a missing cartridge is detected.
X = "B" or "C" head and yy = ink color such as Lc.
o XInkENDyy
Describes which cartridge is empty if an empty cartridge is detected.
X = "B" or "C" head and yy = ink color such as Lc.
[Pause] returns you
to previous menu
[SelecType]
[Item]
Sen: CR Origin xxx
Sen: PF Origin xxx
Sen: Cover xxx
Sen: Lever xxx
Sen: PaperEdgeAD xxx
Sen: PaperFrontAD xxx
Sen: PaperRearAD xxx
Sen: Paper Wide
Sen: HeadSlide xxx
Sen: Temp B 20° C
Sen: Temp C 20° C
Sen: Lever B Down
Sen: Lever C Up
Sen: B Ink ID 7
Sen: C Ink ID 7
Sen: Y Ink ID 7
Sen: M Ink ID 7
Sen: Lc Ink ID 7
Sen: Lm Ink ID 7
Sen: B Ink NOT B
Sen: C Ink NOT Lm
Sen: B Ink END B
Sen: C Ink END Lm